Homepage

Desiccation

DESICCATION (from the Lat. desiccare, to dry up), the operation of drying or removing water from a substance. It is of particular importance in practical chemistry. If a substance admits of being heated to say 100°, the drying may be effected by means of an air-bath, which is simply an oven heated by gas or by steam. Otherwise a desiccator must be employed; this is essentially a closed vessel in which a hygroscopic substance is placed together with the substance to be dried. The process may be accelerated by exhausting the desiccator; this so-called vacuum desiccation is especially suitable for the concentration of aqueous solutions of readily decomposable substances. Of the hygroscopic substances in common use, phosphoric anhydride, concentrated sulphuric acid, and dry potassium hydrate are almost equal in power; sodium hydrate and calcium chloride are not much behind.

Two common types of desiccator are in use. In one the absorbent is placed at the bottom, and the substance to be dried above. Hempel pointed out that the efficiency would be increased by inverting this arrangement, since water vapour is lighter than air and consequently rises. Liquids are dried either by means of the desiccator, or, as is more usual, by shaking with a substance which removes the water. Fused calcium chloride is the commonest absorbent; but it must not be used with alcohols and several other compounds, since it forms compounds with these substances. Quicklime, barium oxide, and dehydrated copper sulphate are especially applicable to alcohol and ether; the last traces of water may be removed by adding metallic sodium and distilling. Gases are dried by leading them through towers or tubes containing an appropriate drying material. The experiments of H. B. Baker on the influence of moisture on chemical combination have shown the difficulty of removing the last traces of water.

In chemical technology, apparatus on the principle of the laboratory air-bath are mainly used. Crystals and precipitates, deprived of as much water as possible by centrifugal machines or filter-presses, are transported by means of a belt, screw, or other form of conveyer, on to trays staged in brick chambers heated directly by flue gases or steam pipes; the latter are easily controlled, and if the steam be superheated a temperature of 300° and over may be maintained. In some cases the material traverses the chamber from the coolest to the hottest part on a conveyer or in wagons. Rotating cylinders are also used; the material to be dried being placed inside, and the cylinder heated by a steam jacket or otherwise.

Note - this article incorporates content from Encyclopaedia Britannica, Eleventh Edition, (1910-1911)

About Maximapedia | Privacy Policy | Cookie Policy | GDPR